Panavise In Dash Mount Nissan Maxima (w/o NAV) 07 08, Versa 07 10

Brand New PanaVise Custom InDash Mount for the2007-08 Maxima& Versa Model #:751311407 ThePanavise InDash Custom Mount eliminates exposed holes in vehicle for clean, easy, andnearly invisible phone mount installation. Proudly made in theUSA from the highest qualityheavy gauge steel, this Panavise Custom Indash Mounthas been fitted and producedspecifically for yourcar to provide the utmost convenience and practicality. Complete mountinginstructions areincluded with your purchase and are also available below. Compatible Cars: 2007-2008 Nissan Maximawithout Navigation 2007-2009 Nissan Versa; Mounting Instructions Mounting Location: Right Side of Radio J R Tools Required: Dash Tool, Hook tool Hardware Included: (2)O-#8-32 Acorm Nuts Step# 01 Versa 2007 Instructions,Start Here:See STEP#5 for Maxima07. Begin by removing the top cover above the radio. Starting at the front of the cover. Insert the hook tool in the front of the cover and pulling toward you with your hands at the same time to release (4) clips. It will pop off all at once. Lift up the top to remove the (2) exposed screws at the top of the radio. Step# 02 With your hands an hook tool assist, pull off the air vents/cubby /radio bezel, releasing (6) clips. Step# 03 Remove the (4) radio/display screws with the Phillips screwdriver. Pull out the radio/display assembly enough to get at the (2) T-20 Torx screws on the right side of the radio. Place the InDash by PanaVise Mount bottom piece onto the right side of the radio with the joggle aligned up with the radio and reinstall the (2) screws. Step# 04 Carefully replace the radio and radio bezel. To replace the bezel start by inserting the top (2) clips into place. Continue to snap the clips into place. A slight adjustment of the mount may assist to reinstall the radio/display bezel. Reconnect the air bag light plug. Replace the console and shifter bezels in reverse order. Step# 05 MAXIMA 2007, Begin Here: Remove the shifter knob by pulling down

• Made in USA from 14 Gauge Steel, powder urethane coated.
• For clean, easy, nearly invisible phone mount installation
• Professional Installation Recommend
• Properly install your cellular phone or hands-free kit without entering the airbag deployment zone