Hand Crank Tarp Roller Kit for Dump Truck Trash Hauler and Trailer Manual Pull - DTR Series Tarp Roller kit - Allen Wrench Included (No Tarp)

Note: This Roller kits package DO NOT include Tarps and Retention Bows.Our CRANK AND PULL tarping system is a manual cab level crank kit that is perfect for landscape trailers, dump trailers, and medium to light duty truck bodies. This kit is the answer to our partners looking for the most affordable, easiest to operate, nothing in the way tarp system.Mounts on the front of any length boxFits box widths up to 8' 6"; 103" aluminum extruded standard tarp axle is 1-1/2" in diameter and can be cut to whatever width you needCan be used with tarps up to 40' longNOTE: Tarps ordered for use with this system should measure at least 4" less than the width of your mounted axleSpring-loaded, break-away crank handleSteel powder-coated mounting brackets and sealed bearings.This Kit Includes:(1) Cab Level Tarp Axle with 1" Axle Bearing with Flange 3/4" Hole(1) Driver Side Cab Level Bracket and Passenger Side Cab Level Bracket(1) 3/8" Derby Rope(1) Cab Level Crank Handle(1) Steel Sprocket(2) 15" Bungee Strap with J Hook(4) 3 1/2" J Hooks (Dia: 11.8mm)Hardware:(5) 1/4" x 1" Hex Head Bolt(5) .8ID x T.2mm Washer(4) 3/8"-16 x 1" Hex Head Bolts, 3/8" Nylon Nuts, and 3/8" Lock Washers(1) 1/4"-20 x 2" Hex Head Bolt(1) 1/4" Nut(8) 1/4" x 1" Philips Head Self-Tapping Screw(3) Allen WrenchesInstalling Pull RopeAttach the free end of the Pull Rope to the center of the Rear Pull Bar, through the grommet, with the cut end facing upwards. Cut the rope to the desired length, and tie a knot.Mount two J-hooks, with the supplied self-tapping bolts, opposing each other near the rear of the dump (typically on the gate) to secure the Pull Rope in the covered position.Mount two J-hooks with the supplied self-tapping bolts opposing each other near the front of the dump to secure the Pull Rope in the uncovered position.

• NOTE: NO TARP, NO RETENTION BOW!!! IN THIS LISTING. NOTE: HAND CRANK ROLLER KITS ONLY.
• Direct replacement for DTR series dump tarp roller kits without tarp.
• Extruded aluminum hexgon roller axle telescope to exact bed width of dumps or trailers up to 103" wide.Tarp axle is 1-1/2" in diameter and can be cut to whatever width you need
• This hand crank tarp roller kit Features Cast bearings and zinc plated hardware. Spring-loaded, break-away crank handle. Mounts on the front of any length box. Detent Locking Handle To Stop Tarp From Unrolling
• NOTE: Tarps ordered for use with this system should measure at least 4" less than the width of your mounted axle